Cybernetics V Series CY-miSAN-V Manual de instrucciones descargar pdf (Pagina 41)

41 Operating the Web Control Panel

Cybernetics UM-MV-86-B1-0801

To begin formatting the disks, click

Format all disks. The miSAN-V-Series will then

erase the data stored on all disks used for the virtual tape cache. The message box

on the tab will change to show that the miSAN-V-Series is formatting the disks. Wait

for the formatting to complete, and then proceed to create virtual tapes (See “Creating

Virtual Tapes” on page 29).

Configure Virtual Devices

This item allows for setting the number of standalone tape drives and stackers. The

maximum number of virtual tape drives allowed, whether standalone or stacker, is

based on the model configuration. When selected, a window will appear showing the

current number of virtual devices (See Figure 3-13). To set the number of standalone

tape drives or stackers, enter the desired quantity for the device, and then click OK.

When configuring a stacker, the number of tape drives and slots must also be set. The

device tree on the “Devices” tab will reset to update the configuration changes (See

“Deciding What Kind of Virtual Tape Drives to Create” on page 27).

Figure 3-12 Create Virtual Tapes “Format disks” Tab

Caution

Make sure to format the disks before creating virtual tapes for the first

time. Failure to do so may cause errors when creating the virtual tapes.

After creating tapes, remember that formatting the disks will erase the

data stored on all disks used for the virtual tape cache.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 189 190

Sin comentarios

Cybernetics V Series CY-miSAN-V Manual de instrucciones Pagina 41