Cybernetics V Series CY-miSAN-V Manual de instrucciones descargar pdf (Pagina 89)

89 Operating the Web Control Panel

Cybernetics UM-MV-86-B1-0801

physical stacker and a table, on the right, with all the virtual tapes assigned to

devices (See Figure 3-42).

To assign a physical tape to a virtual tape for copying, first, select the desired

physical tape cartridge in the “Physical tapes” listbox. Then, select the row for the

desired virtual tape in the “Virtual tapes” table. Finish by clicking the

-> button,

which assigns the physical tape name to the virtual tape “Copy source” (See Fig-

ure 3-43). (The

Help button provides an explanation of how to set up the copy.)

Once all the desired physical tapes have been assigned, click

Start. After clicking

Start, the copy job will begin immediately or will be queued until the physical

stacker tape drive becomes available. During the copy process, the physical

stacker tape drive device panel will show the “Drive state” as “Copying to virtual

tape name”.

• Host access

Host access enables you to access the physical stacker directly from your host

backup software by proxy using a virtual tape drive or stacker. This is often useful

for restoring directly from a physical tape.

Figure 3-42 “Load tapes onto disk” Window

Figure 3-43 Assigning Physical Tapes To Copy

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 189 190

Sin comentarios

Cybernetics V Series CY-miSAN-V Manual de instrucciones Pagina 89